Xrite i1 display pro review software#
The software will then to a similar check for the screen brightness. Once you’ve hit the target click Next to carry on. Once I have three green ticks I usually carry on until I get the Target and Current value as close to the target as I can. Always pause for a second or two after making each change to allow the measurement to refresh.
They are signal adjustments not real hardware adjustments, but on a good quality monitor they will get the screen to a certain white point better than adjusting the graphics card look up table will. Remember these are not real gain values like they were in the days of CRT monitors but just look up tables in the monitor firmware. I normally start by using a Kelvin value adjustment on the monitor to get close and then switch to adjusting the individual RGB gain values, starting with the red. The arrows indicate which way each colour needs to be adjusted. You are trying to get all three to have a green tick. A graphic will show you if the red, green, or blue values on your screen need adjusting.
It will display a few tones and then bring up the White Point Adjustment window. The software will do a contrast test that almost all monitors pass and then go onto measuring the white point of the screen. For them, X-Rite has just released the new i1 Display Studio which replaces the ColorMunki Display. On the other hand, this software is not intended for beginners because even in "basic" calibration mode, there are many options and will not always talk to novices. So we have to deal with the ultimate refinements in hardware and software.
To this, the i1Display Pro adds countless adjustment possibilities and benefits from the latest technological advances to ideally calibrate all screens on the market, even the latest wide-range LCD tiles or laptop or iMac screens and perform all possible quality controls.
Xrite i1 display pro review plus#
This new i1Display Pro PLUS model is just a version of the i1Display Pro capable of calibrating particularly bright monitors. In 2019 and at 200€, it is no longer the most expensive sensor on the market since the release of the newData Color Spyder X and the new i1 Display Pro version released in October 2019. Everything was new: the colorimeter with (organic) glass filter like the new Colormunki Display and the software. In July 2011, X-Rite launched the replacement for the famous Eye One Display II, the i1 Display Pro and its new i1Profiler software.